I am looking for more info on setting the following line in the recipe file, most importantly, the potential negative affects (Larger file sizes, longer publishing times). I do not find any information on it in the PTC KB, I am curious if anyone has played around with this setting much.
For the most part, the way our system is currently set up is acceptable. Most parts publish with satisfactory accuracy. However, some parts (i.e. a small part with a large copy geometry surface) will publish with terrible accuracy. Setting this in the RCP to .001 does solve the issue, I am just curious if it has any unintentional drawbacks.
adapter/dglTolPerc=.001
Thanks for reading,
Colten